Rage Ultra is the world’s best sanding body filler. Its unparalleled sanding qualities are a result of the patent pending formula that contains renewable technology. Its non-sag formula has excellent filling properties, while eliminating the need for finishing putty. Rage Ultra contains ZNX-7® and is part of the Metalworks® system.

APPROVED SUBSTRATES:  Steel  Stainless Steel  SMC  Fiberglass  Galvanized Steel  Aluminum  Sanded OEM Paint  Silicon Bronze Welds

For best results, clean, degrease and dry the surface. Use 40–80 grit to remove the paint and featheredge. Stir the filler and knead the hardener before using. Add the hardener to the filler 2% by weight (add a ribbon of cream hardener from edge to edge across the center of a 4-inch diameter puddle). Approximate setting time is 3–5 minutes at 72°F (22°C). Apply in layers with firm pressure. Do not apply all at once. Sand body filler with 80-180 grit sandpaper. If necessary, re-apply Rage Ultra to fill any pinholes or low spots, allow filler to dry and then sand with 180 grit sandpaper. Finish sand with 180 grit. Allow minimum of 20 minutes sanding time over silicon bronze welds. NOTE: For optimum performance apply 440 Express before applying primer surfacer. Evercoat leads the industry in the use of “green” technology. Evercoat Products produce a quality collision repair, every time, everywhere.